Super Soft Shokupan/ Japanese Milk Bread (Sponge Method)
Course: Bread
Cuisine: Asian
Prep Time: 1 hourhour20 minutesminutes
Cook Time: 40 minutesminutes
Proof the dough twice:: 2 hourshours
Total Time: 4 hourshours
Servings: 10slices
Calories: 186kcal
Author: Marvellina
You will be blown away by how incredibly soft and fluffy this milk bread is. The sponge and dough method also contributes to a loaf of bread with a nice complex flavor with a softness that stays for days.
Prepare the sponge: (at least 1 hour or up to 24 hours before)
Combine all the ingredients for the sponge in a mixing bowl of a standmixer (if you don't plan to use it for other things). Use a whisk to whisk for about 2 minutes. The consistency is like a thick batter. Cover tightly and let it ferment until doubles in volume at a warm place for at least 1 hour or up to 4 hours if you plan to bake on the same day
If you want an even greater flavor, once the sponge has doubled, cover it tightly and put it in the fridge for 24 hours (no longer than that)
Prepare the dough:
Combine all the ingredients for the dough, except for the butter. Add this to the bowl where you have your sponge. Stir the mixture with the dough hook to combine roughly so the dry ingredients won't start flying when you turn on the machine. Start mixing at speed 2 for about 1 minute and then increase to speed 4 and continue to knead for 5 minutes to get a soft dough that won't entirely clear the sides of the bowl yet and still stick to the bottom of the bowl
Add the softened butter in 3-4 additions, pat by pat. Add butter only after the dough has roughly absorbed the butter, in about 2-3 minute intervals. Let it continue to knead until the dough is smooth, shiny, and elastic, still slightly sticky. You may have a bit of dough still sticking to the side of the bowl, that's ok. This may take an additional 7-10 minutes (or longer) of kneading. It should reach a windowpane stage. When you gently stretch the dough thinly, it shouldn't tear easily. If it does, knead a bit longer.
Lightly oil your hands and pick up the dough and round it up into a smooth ball. It's a very soft dough and you know this bread is going to be ultra soft and fluffy.
First proofing:
Place the dough in a lightly oiled bowl. This is optional but I like to put it in a round container, about 1 quart-size so I can monitor when it doubles in volume. Gently press the dough down so it's flat and fill up the container. I will mark the side of the container with masking tape where the dough would double in volume. This may take about 45 minutes to 1 hour at a warm place. It may take longer if your room temperature is cooler
Shaping:
Once the dough has doubled, transfer it to a work surface. Deflate the air by pressing and folding the dough a few times. Divide into 3 equal portions. Dividing the dough into 3 helps the dough to rise taller and more stable since this is a very soft and delicate dough
I encourage you to weigh the dough so they will be the same size. Round them up into dough balls, keep them covered and let them rest for 10 minutes to relax the gluten
Brush your loaf pan with some oil all over. I use a 7 1/2 x 4 1/2 x 4 1/2 tall loaf pan. You can also use 8 1/2 x 4 1/2 loaf pan. Work with one dough at a time. Roll the dough out into a rectangle, about 12 x 8 inches roughly, trying to deflate as much air bubbles as possible at the same time so there won’t be holes inside your bread later. Fold both sides to the center. Roll it up tightly from the short side and pinch the seam to seal. Place this inside the loaf pan. Repeat with another two doughs.
Place all the shaped dough side by side. Gently press them down to fit the pan and so that they are the same height
Final proofing:
Cover the loaf pan with a plastic wrap. Update: Let it ferment to about 80% of the height of the pan, about 1-inch below the rim of the pan at a warm place. Do a finger poke test: flour your finger lightly and then gently push on the dough. If the indentation stays and the dough slowly sprinsg back, but still leave some indentation, it's done proofing. If it bounces back almost immediately, proof a bit longer
15 minutes before the end of the proofing, preheat oven to 350 F (180 C) for convection oven, 330 F (165 C) for convection oven
Baking:
Combine the egg with water using a whisk. Strain them if necessary so the white won't be in one blob. Brush this thinly on top of the dough. Sprinkle with some white sesame seeds
Place the loaf pan in the middle of the oven and bake for 45-50 minutes. The time is just for reference. You may need to tent loosely with aluminum foil halfway through baking if the top gets browned too quickly.
Due to the softness and airiness of the dough, we have to ensure the bread is fully baked so that the crust can support the height or it can collapse if it's underbaked. I always check the internal temperature by poking a digital thermometer at around 45 minute-mark, right into the center of the loaf, usually it has reached 190 F (88 C). If it hasn't, bake 5 minutes longer and check again until it reaches that internal temperature.
Cool down:
Remove from the oven and drop the pan on the counter once or twice. Brush with some melted butter on top if you like. This is a very soft and delicate bread. Let it sit in the pan for 10 minutes. Then gently loosen the sides with spatula and let it cool down on its side first for about 15 minutes and then let the bread stand in its upright position and cool completely on a cooling rack.
Do not cut into freshly baked bread for at least 2 hours. The bread may collapse and worse, turns gummy
Video
Notes
Different flour has different absorbency to liquid. You can use 170 grams of water to prepare the sponge if you aren't sure the flour you use can handle a higher hydration. When you prepare the dough and if it's too dry, you can always add more to compensate for it
Dry milk powder helps to keep the bread softer. So I encourage you to use it instead of replacing it with liquid milk. If you must substitute, replace all the water in the sponge with milk, BUT, bring the milk to a boil (scalding the milk) and then turn off the heat and let it cool down completely before you make the sponge or it will kill the yeast. Read my post above for detail on why we want to scald the milk.